Mounting Your Soundbar On A Wall (Optional) - Insignia NS-SB515 User Manual

Mounting your soundbar on a wall (optional)

You will need:
HOLD THE LEVEL TO THE TOP EDGE OF THIS TEMPLATE
Hold this template in the location you want, Wall Wall
TOOLS NEEDED Determine where you would like to mount and use a level to level it, then tape it to the Soundbar
Drill a hole here Wall mount template Center Line the soundbar. The center line of the template wall.
should match the center of the TV.
Locate/Position holes onto studs behind Note: If you are mounting to drywall, use a Wall Anchor 1/4 in.
studfinder to locate studs. A wall anchor is not (6 to 8 mm)
drywall when possible, - o r use anchors for needed if you are attaching to a stud. Remove the template from the wall. Fasten two screws (not supplied) to the wall.
mounting You must use suitable wall anchors (not The screw heads should protrude from the wall
supplied) if you cannot mount the soundbar to approximately 1/4 in. (6 to 8 mm). The screw
Wall Screws (2) Warning: Improper installation can result in serious injury or width must be about 3/16 in. and the screw Align the speaker hanging brackets with the
anchors (2) #10 × 1 ½ in. (3.8 cm) damage to your soundbar. Drill two holes at the indicated points. available wall studs. head about .3 in. (7.6 mm) to 3/8 in. (9.5 mm).
wood screw (or similar) screws, then hang the soundbar on the screws.
If necessary, seek the assistance of a professional.
Center Line
Scale: 1/1
Wall mounting template
Tape measure
1 Select a location close to your TV and directly in front of the
viewing/listening position. For best sound quality, choose a location
where sound waves are not blocked by furniture or other obstacles.
2 If you are mounting your soundbar to drywall, use the stud finder to find
the studs and mark the locations.
3 Position the supplied wall mount template to the wall where you want to
mount the soundbar. Make sure that the template is level and note if it's
aligned with a stud, then tape the template to the wall.
4 Drill two holes into the wall where the template indicates, then remove
the template.
5 If needed, install wall anchors (not included) into the holes you drilled,
using the instructions that came with your anchors.
18
Drill a hole here Center Line
Wall
Level
Tape
www.insigniaproducts.com
Insignia Soundbar with Wireless Subwoofer
Stud finder
Drill and
(optional for wood
drill bit
stud installation)
Wall anchors (2)
Caution
Make sure that you use wall anchors that are suitable
to your wall type if you need to mount the soundbar
to drywall, concrete, or similar wall type.
Notes
• If you have drilled into a stud, wall anchors are
not required.
• If you cannot drill into wall studs and must drill
into drywall, concrete, or another type of wall,
wall anchors are required. See the instructions
that came with your wall anchors to determine
the drill bit size.
Hammer
Screwdriver
Screws (2) - #10 x 1-1/2 in
(3.8 cm) wood screw (or similar)