Software Update - Sharp LC-22DV510E Service Manual

24.6. USB Operations
USB operations option cannot be used directly. It can be used for updating panel tool, hw configuration
etc.
24.
25.

SOFTWARE UPDATE

In MB60 project there is only one software. From following steps software update procedure can be seen:
Analog - Digital SW update via USB

MB60_en.bin, mboot.bin and usb_auto_update_T4.txt documents should copy directly
inside of a flash memory(not in a folder).

Put flash memory to the TV when TV is powered off.

Power on the Tv .
1. Please copy the files to USB (root).
 While the Tv is switch on press OK button consecutively.
• mb60_en.bin
• mboot.bin

The Tv's Led will blink faster then stand_by mode.
• usb_auto_update.txt

If First Time Installation screen comes, it means software update procedure is successful.
2. Turn power to OFF by mechanical switch(rocker switch) or removing AC
plug. And plug the USB to TV
3. Keep pressing OK key from remote controller and then turn the TV power
To reach the latest sw file please use;
to ON(by mechanical switch or by inserting the AC plug) and keep OK key
https://www.vestelservice.com/100359/New_Projects/Sharp/Sharp_2011/9_Customer_support/SW/
pressed until the stanby led blinks rapidly(rapid blinking is faster than
normal blinking)
4. When the led is started to blink rapidly, you can release the OK key.Please
wait approximately for 1-2 minutes.
5. When the blinks of led is stopped, TV opens autamatically with the new
SW.
SOFTWARE UPDATE
71
LC-22DV510
LC-24DV510
1