Interrupting Operation; Finish Operation - Kärcher MV 3 Operating Instructions Manual

Wet vacuum cleaning
For vacuuming up moisture or wet-

ness pay attention to the correct
floor nozzle insert and connect the
corresponding accessories.
Caution:
Immediately switch the appli-
ance off or pull the power plug if
foam forms or liquids escape!
Do not use a filter bag!
Note: If the container is full, a float
closes the suction opening, and the ap-
pliance works at a higher speed.
Switch off the appliance immediately,
and empty the container.
Working with electrical power
Illustration
Adapt the adapter to the connection

diameter of the electric tool using a
knife if necessary.
Connect the adapter to the handle

of the suction hose and connect it to
the electric tool connection.
Connect the mains plug of the elec-
tric power tool to the vacuum clean-
er.
Illustration
Switch the vacuum cleaner to Posi-

tion II and start working.
Note: As soon as the electric tool is
switched on, the suction turbine starts
with a 0.5 second delay. If the electric
tool is switched off, the suction turbine
continues to run for approx. 5 seconds
in order to vacuum up the remaining
dirt in the suction hose.
10
tools
Blowing function
Cleaning hard to reach locations or,
where vacuuming is not possible, like
leaves from a gravel bed.
Illustration
Connect the suction hose to the

blower connection, this will activate
the blower function.

Interrupting operation

Turn off the appliance.

Illustration
Hook the floor nozzle into the park-

ing position.

Finish operation

Turn off the appliance and discon-

nect the mains plug.
Empty the container
Illustration
Remove the appliance head and

empty the reservoir.
Storing the appliance
Illustration
Stow away the mains cable and ac-

cessory at the machine. Store the
appliance in a dry room.
– 10
EN