AEG LAVATHERM 37720 electronic Operating Instructions Manual page 26

Something not working?
The door cannot be opened
with the DOOR button
The door cannot be closed
The drum illumination does
not work
The remaining running time
display changes rapidly.
The dryer terminates the
drying process automatically:
END is displayed shortly after
program start; no display of
the extent of drying
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END display is illuminated
- acoustic signal sounds
- discontinuation of the
drying process
- Program run display is flash-
ing
- error code C6 is displayed
If after these checks, the tumble dryer still does not work, contact your
local AEG Service Force Centre.
26
Symptom Possible cause
Electric mains plug not
connected
Program selector set to
OFF
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
The program selector is in
the OFF position
The bulb needs replacing
The remaining running
time is adjusted
automatically depending
on the type of items
being washed, the
washing time and the
degree of dampness.
Too dry or too little
laundry filled-in for the
selected program
SPECIAL CARE button
pressed and too much
laundry filled-in
Too much laundry
filled-in
Laundry too damp
Solution
Connect the mains plug
Set a program. The fill-in
door can be opened at
any time by pressing
firmly against the door
(pressing location
Replace the fluff filter
and ensure the filter lid is
closed
Turn the program selector
dial to LIGHT
Replace bulb
Automatic process. There
is no unit fault.
Select time program or
higher drying stage (e.g.
EXTRA DRY instead of
INTENSIVE DRY)
Check the program
selection: SPECIAL CARE
button appropriate only
for laundry amounts up
to 2.5kg
Reduce the amount of
laundry filled-in
Pre-dry the laundry more
thoroughly
)