Daewoo KOG-37050P Service Manual page 12

4. Method to reduce the gap between the door seal and the oven front surface.
(1) To reduce gap located on part ' A' .
Loosen a screw on stopper hinge top, and then push the door to
contact the door seal to oven front surface.
Tighten a screw.
(2) To reduce gap located on part ' B' .
Loosen two screws on stopper hinge under, and then push
the door to contact the door seal to oven front surface.
Tighten two screws.
NOTE
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
DISASSEMBLY AND ASSEMBLY
11
2
.