Maintenance And Care - Rinnai RO-M2561-SM Operation & Installation Manual

Disconnect the power supply cord before
carrying out any cleaning or maintenance
activities.
Cleaning the Oven Interior
The oven interior can get hot during use. Ensure
that the oven has sufficiently cooled down before
carrying out cleaning activities.
•
Keep the oven cavity, door and door seal
surfaces clean. Food residues, spill overs and
grease splatters stained on the oven walls, door
seal and door surface reduce the efficiency of
the oven and may cause hazards to user.
•
The oven interior and door can be cleaned
using a damp cloth. Mild detergent may be used
if the oven gets very dirty. Avoid the use of
abrasive cleaners as they may stain, streak or
dull the oven interior and door surface.
•
To loosen stubborn deposits, boil a cup of water
in the microwave oven for 2 – 3 minutes.
•
To remove odors from the oven interior, boil a
cup of water with a few spoonful of lemon juice
for 5 minutes.
•
The door should be kept clean at all times and
checked regularly for any damage.
•
Avoid water or small particles penetration into
small vents in the appliance.
Warning: Do not remove the waveguide cover
inside the oven cavity.
Never use a high pressure cleaner or steam
cleaner to clean the appliance. The steam could
reach the electrical components and result in a
short circuit.
Cleaning the Oven Exterior
•
The outside can be easily cleaned with mild
detergent and warm water. Wipe dry with a lint-
free cloth. Avoid using corrosive or abrasive
products that could damage the surface.
•
For stainless steel surfaces, always wipe in the
direction of the grain so as not to scratch the
surface. For tougher stains, use a specific non-
abrasive product
manufacturer's instructions).

MAINTENANCE AND CARE

(please observe the
•
Open the door before cleaning to deactivate the
control panel. Keep the control panel dry. Wipe
dry with a soft, damp cloth. Avoid using
excessive amount of water.
•
Keep the ventilation openings free from water
seepage and small particles.
Oven light
Do not attempt to replace the oven light by a non-
qualified technician. Please contact your local
Rinnai Customer Care Service for service.
Cleaning the Accessories
Turntable and support
•
Always keep the roller ring clean so that the
turntable can turn smoothly and avoid
excessive noise.
•
Wash with mild soapy water and dry
thoroughly.
•
Fit the turntable in proper position after
cleaning. See "Fixing the Turntable" in this
manual.
To avoid the turntable from breaking:
•
Before cleaning the turntable with water, leave
the turntable to cool.
•
Do not place anything hot on a cold turntable.
•
Do not place anything cold on a hot turntable.
Grilling rack
•
Wash and dry the grilling rack after each use. It
can be washed by hand or dishwasher. Soak in
hot soapy water to remove stubborn grease.
Clean with a brush or sponge.
For purchase of spare parts, please check with
your local Rinnai Customer Care Centre.
12