Makita HM1111C Instruction Manual page 7

This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
lubricated every time the carbon brushes are replaced.
Send the complete tool to Makita Authorized or Factory
Service Center for this lubrication service.
1
011177
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle. Note that
the top screws are different from other screws.
1
2
011178
Disconnect the connector by pulling them.
1
2
011179
Loosen the five screws on crank cap and remove the
crank cap.
011180
Wipe out the old grease inside and replace with a fresh
grease (30 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
1. Screws
1
1. Connector
2. White
3. Black
3
1. Screwdriver
2. Crank cap
1. Grease
1
amount of grease (approx. 30 g) can cause faulty
hammering action or tool failure. Fill only with the
specified amount of grease.
CAUTION:
Be careful not to damage the connector or lead
•
wires especially when wiping out the old grease.
To reassemble the tool, follow the disassembling
procedure in reverse.
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the connector or lead
•
wires especially when installing the handle.
1
2
011181
Connect the connector firmly and then reinstall the
handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point (SDS-max)
•
Cold chisel (SDS-max)
•
Scaling chisel (SDS-max)
•
Clay spade (SDS-max)
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Plastic carrying case
•
7
1. Connector
2. White
3. Black
3
or attachments
Only use accessory or
are