Advertisement
_
Extend
Window
Filler
Panels
and
attach
to
angle
rail:
top
1. Carefully
raise window to expose filler panel locking screws on top angle rail. Loosen screws so filler panels slide
easily.
2. Extend panels to fill window opening completely.
Tighten locking screws on top (FIG. 16).
3. Close window behind top angle rail.
4. Attach the top angle rail to window frame: Use a 3/32" drill bit to drill one hole through the hole in the middle of top
angle rail into the window frame, and drive one 1/2" HEX-HEAD
locking screw through the hole in the middle of top
angle rail into the window frame as shown (FIG. 17).
FIG.16
FIG. 17
-t"7/16"
Locking Screw
and Washer
_
Attach Window Filler Panels to Window Frame
t. Extend the window filler panels out against the window frame.
2. Use a 1/8" drill bit to drill a starter hole through the hole in the
top leg of each window filler panel and into the window sash
(Fig. 18A and Fig. 18B). Connect with one 1/2" long hex head
screw.
_
Install
Window
Sash
Seal
and
Safety
Lock
1. Trim window sash seal to fit window width. Insert it into
space between upper and lower sashes as shown (FIG. 19).
2. Attach right angle safety lock to top window sash as
shown (FIG.20).
3. If necessary, trim weather seals to needed length, peel
off protective backing, and use to plug any gaps. See Fig. 18B.
C
FIG. 18A
I
A, 1/2" long hex head screw
B. left-hand
Window
Filler
Panel Top Leg
C. Window channel
FIG.19
El
FIG.20
install Air Conditioner
into Cabinet and Install
Front Panel to Unit
1/2" long
HEX-HEAD
SCREW
FIG. 18B
........ weather seals
A. 1/2" long hex head screw
FIG. 21
t. Lift air conditioner
and carefully slide into cabinet.
2. CAUTION:
Do not push on controls
OR finned
coils.
3. Be sure air conditioner
is firmly seated towards rear of cabinet.
4. Reconnect
electronics
plug if present, Position vent control lever so that it will thread into its channel in the front
panel (see FIG.21). Hook front panel top tabs into slots on cabinet top, and rotate front panel down so that side tabs
snap into place on cabinet. Insert 4 previously removed screws through front panel and into air conditioner.
5. Insert air conditioner filter. Reinstall the front grille by hooking bottom tabs into slots on Front Panel bottom, then
rotating grille up to snap into place,
_ntrol
correct location
Advertisement
