Opening The Door - AEG LAVAMAT 68480VFL User Manual

14 www.aeg.com
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.

10.11 Opening the door

While a programme (or the Finish In)
operates, the appliance door is locked.
The indicator
CAUTION!
If the temperature and level
of the water in the drum are
too high, you cannot open
the door.
To open the door during the first
minutes of the cycle (or when the
Finish In operates) :
1. Touch the button Start/Pause to
pause the appliance.
2. Wait until the indicator
3. You can open the door.
4. Close the door and touch the button
Start/Pause again. The programme
(or the Finish In) continues.
10.12 At the end of the
programme
• The appliance stops automatically.
• The acoustic signal operates (if it is
activated).
• In the display
• The indicator of the button Start/
Pause goes off.
• The door lock indicator
• You can open the door.
• Remove the laundry from the
appliance. Make sure that the drum is
empty.
• Press the button On/Off for some
seconds to deactivate the appliance.
• Close the water tap.
• Keep the door and the detergent
drawer ajar, to prevent the mildew
and odours.
is on.
goes off.
comes on.
goes off.
The washing programme is completed,
but there is water in the drum:
• The drum turns regularly to prevent
the creases in the laundry.
• The indicator
you to drain the water.
• The door lock indicator
indicator of button Start/Pause
flashes. The door stays locked.
• You must drain the water to open the
door.
Draining the water:
1. To drain the water.
• Touch the button Start/Pause .
The appliance drains the water
and spins with the maximum spin
speed for selected washing
programme.
• Alternatively, touch the button
Spin to change the spin speed
and then touch the button Start/
Pause. The appliance drains the
water and spins. If you set
appliance only drains.
2. When the programme is completed
and the door lock indicator
off, you can open the door.
3. Press the button On/Off for some
seconds to deactivate the appliance.
10.13 AUTO-OFF option
The AUTO-OFF stand-by option
automatically deactivates the appliance
to decrease the energy consumption. All
the indicators and the display go off
when :
• You do not use the appliance for 5
minutes before you touch the Start/
Pause.
Press the button On/Off to activate
the appliance again.
• After 5 minutes from the end of the
washing programme.
Press the button On/Off to activate
the appliance again.
The display shows the end of the last
set programme.
Touch the button Programmes if you
want to set a new cycle.
flashes to remind
is on. The
, the
goes