Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions
[_
REPLACING
THE OVEN
DOOR
(Continued)
3. Open the door as far as it will open. Push the
hinge lock up against the front frame of the oven
cavity, to the locked position. Close the door.
Hinge in Locked
Position
Notch of Hinge
Securely Fitted
into Bottom of
Hinge Slot
F_ FINAL CHECKLIST
, Check to make sure the circuit breaker is closed (Reset) or the circuit fuses are replaced.
. Be sure power is in service to the building.
. Check to be sure that all packing materials
and tape have been removed.
Failure to remove these materials
could result in damage
to the appliance
once the appliance
has been turned on and surface elements
have
heated
OPERATION CHECKLIST
. Check to make sure the Clock display is energized. If a series of horizontal red lines appear in the display,
disconnect power immediately. Recheck the range wiring connections. If change is made to connections,
retest again. If no change is required, have building wiring checked for proper connections and voltage. It is
recommended that the clock be changed if the red lines appear.
, Push down and turn any one of the four surface knobs to "HED" setting to observe that the element glows
within 15 seconds. Turn the knob off when glow is detected.
If the glow is not detected
within the time limit,
recheck the range wiring connections.
If change is required, retest again. If no change is required, have
building wiring checked for proper connections
and voltage.
10
Advertisement
Table of Contents
