Advertisement
Use only the driver bit or socket bit shown
in the figure.
Do
not use any other driver bit or socket
bit.
To install the bit, pull the
sleeve
in the
direction of the arrow and insert the bit
into the
sleeve as
far
as
it will go. Then
release the sleeve to secure the bit.
11
mm
(7/16")
9
mm
(3/8")
Sleeve
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly.
NOTE
:
If the bit i s not inserted deep enough into the sleeve, the sleeve will not return to
i t s
original position and the bit will not be secured. In this case, try re-inserting the bit
according to the instructions above.
7
Advertisement
