ECS H61H2-M16 User Manual page 56

Long Duration Maintained (10)
Use this item to control the time window over PL1 value should be maintained. This
is for Turbo mode.
Short Duration Power Limit Override (Maximum)
Intel(R) Turbo Boost Technology will use this power limit for a very short duration.
After that, the long duration power limit will be honored.
Graphics Core Ratio Limit (23)
This item allows you to control the internal GFX Turbo
Graphics Voltage(1/256) (0)
This item allows you to adjust the internal GFX voltage.
Press <Esc> to return to the M.I.B III menu page.
Chipset OverClocking Configuration
Scroll to this item to view the following screen:
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced
Main Advanced
Memory Multiplier Configuration
Performance Memory Profiles
XMP Profile 1
XMP Profile 2
Memory Timing Configuration
CAS# Latency (tCL)
RAS# to CAS# Delay (tRCD)
Row Precharge Time (tRP)
RAS# Active Time ( tRAS)
Write Recovery Time (tWR)
Row Refresh Cycle Time (tRFC)
Active to Active Delay (tRRD)
Write to Read Delay (tWTR)
Read CAS# Precharge (tRTP)
Four Active Window Delay (tFAW)
Performance Memory Profiles (Automatic)
This item enables you to set the Performance Memory Profile.
XMP Profile 1/2 (Supported/Not Supported)
These items show the information of Performance Memory Profile.
CAS Latency (tCL) (9)
This item determines the operation of DDR SDRAM memory CAS (colulmn address
strobe). It is recommended that you leave this item at the default value. The 2T
setting requires faster memory that specifically supports this mode.
52
Chipset M.I.B III
Chipset M.I.B III
[Automatic]
Supported
Not Supported
9
9
9
24
10
74
4
5
5
20
Version 2.15.1229. Copyright (C) 2012, American Megatrends, Inc.
H61H2-M16 USER MANUAL
ratio.
Boot Security Save & Exit
Boot Security Exit
The selection of Performance
Memory Profiles which impacts
memory sizing behavior.
Enter : Select
+/- : Change Opt.
F1:General Help
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
:Select Screen
:Select Item