Skoda Citigo Operating Instructions Manual page 9

Depending on the connected audio source, the output volume on the external au-
dio source can be changed.
You can also change the input sensitivity of the external audio source
Setting special functions, in order for the play function volume of the external au-
dio source to adapt to other audio sources or to avoid distortions of the play func-
tion volume.
Conditions for proper connection
›
Only USB devices with the specification 2.0 can be connected.
›
The version of the file allocation table FAT (File Allocation Table) of the connec-
ted device must be FAT16 ( <2 GB) or FAT32 (> 2 GB).
›
In order to replay from a unit with a hard disk (HDD) which includes a large data
volume, it can lead to a time delay when reading in the overview of the music
data.
›
In order to replay from a unit, which includes a complicated folder structure, it
can lead to a time delay when reading in the overview of the music data.
›
The folder structure in the connected unit must not exceed a depth of 8 levels.
One folder must not contain more than 1000 data.
›
A USB extension cable or USB distributor (HUB) must not be used to connect
the unit.
WARNING
On no account place an external audio source on the dash panel. It could be
■
thrown into the passenger compartment during sudden driving manoeuvres,
injuring the occupants.
On no account place an external audio source close to the airbags. It could
■
be thrown into the passenger compartment when the airbags are deployed,
injuring the occupants.
You must not hold the external audio source in the hand or on the knees
■
while driving. You could make sudden manoeuvres in the passenger compart-
ment and injure the occupants.
Always guide the connection cable of the external audio source in such a
■
way that is does not restrict you when driving.
CAUTION
The AUX input must only be used for audio sources!
Note
If an external audio source is connected via AUX, which is equipped with an
■
» page 4,
adapter for external power supply, it can occur that the audio signal is interrup-
ted. This depends on the quality of the adapter which is used.
The loudspeakers in the vehicle are matched to a power output of the radio of
■
4x20 W.
For the equipment sound system, the loudspeakers are matched to a power
■
output of the amplifier of 4x40 W + 6x20 W.
Ð
7
General information