ADJ ON-X User Instructions page 7

ON-X
DOWN buttons to select "ON" to keep the LED display on at all
times, or "OFF" to switch to have the LED display switch off after 10
seconds.
DISP -
This function will reverse the display 180º.
1. Press the MENU button until "DISP" is displayed, press ENTER.
2. Press ENTER to "flip" the display. Press ENTER to "flip" it again.
Press ENTER when you have made your desired setup.
3. Press ENTER to confirm. To make you LED display reappear again
press any button.
TEST
- This function will run a self test program.
1. Press the MENU button until "TEST" is displayed, press ENTER.
2. The fixture will now run a self test.
FHRS
- With this function you can display the running
time of the unit.
1. Press the MENU button until "FHRS" is displayed, press ENTER.
2. The running time of the fixture will now be displayed. Press MENU
to exit.
VER
- Use this function to display the Software version of
the unit.
1. Press the either the MENU button until "VER" is displayed, press
ENTER.
2. The display will show the software version.
RSET
- This function will reset the unit.
1. Press the MENU button until "RSET" is displayed. Press the
ENTER button and the unit will reset itself.
ADJ Products, LLC - www.adj.com - ON-X User Manual Page 12
System Menu ON-X
To enter the Offset Menu, press the ENTER button for at least 3 sec-
onds. In this submenu you are able to adjust the home positions of
the tilt motor positions.
Tilt Offset
any of the 2 bars.
1. Press the ENTER button for at least 3 seconds, then press the UP
or DOWN buttons so that either "Til 1" or "Til 2" is displayed, and
press ENTER.
2. Use the UP and DOWN buttons to make your adjustments, and
then press ENTER to confirm. Press the MENU button for one second
to exit.
- Adjustment of the tilt home position for
ADJ Products, LLC - www.adj.com - ON-X User Manual Page 13
Offset Submenu