Before Installing This Product; To Prevent Damage; Notice For The Blue Lead - Pioneer AVIC-F700BT Operation Manual

Section
18 (
Connecting the System)
(~----~)
Before installing this
product
• This product is for vehicles with a 12-volt
battery and negative grounding, Check the
battery voltage of your vehicle before instal-
lation.
• To avoid shorts in the electrical system, be
sure to disconnect the (-) battery cable be-
fore beginning installation.
• To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads. which if left uncovered may
cause a short circuit.
• Attach the connectors of the same color to
the corresponding colored port, i,e., blue
connector to the blue port, black to black,
etc.
• Refer to the owner's manual for details on
connecting the power amp and other units,
then make connections accordingly,
• Since a unique BPTL circuit is employed,
do not directly ground the
e
side of the
speaker lead or connect the
e
sides of the
speaker leads together, Be sure to connect
the
e
side of the speaker lead to the
e
side of the speaker lead on this navigation
system.
• If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
• Never connect speakers with an output rat-
ing of less than 50 W channel or impe-
dance outside of the 4 ohms to 8 ohms
specifications to your navigation system.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Notice for the blue lead
• A signal is output through the blue lead to
control the antenna of your vehicle. The
timing varies depending on the setting. (For
more detailed information on changing
[Ant CTRL] mode, refer to "Operation Man-
ual".)
• When [Ant CTRL] mode is set to [Radio],
the vehicle's antenna can be stowed or
turned off by following the instructions
below.
No ACC position ACC position
To prevent damage
AWARNING
• When replacing the fuse, be sure to only
use a fuse of the rating prescribed on the
fuse holder.
• When disconnecting a connector, pull the
connector itself. Do not pull the lead. as
you may pull it out of the connector.
• This product cannot be installed in a vehi-
cle without ACC (accessory) position on
the ignition switch.
m
En