Advertisement
Installing or removing driver bit or drill bit
CAUTION :
Always be sure
that
the tool is switched off and
the
battery cartridge
is
removed before
installing or removing the bit.
Hold the ring and turn the
sleeve
counter-
clockwise to open the chuck jaws. Place
the bit in the chuck as far as it will go.
Hold the ring firmly and turn the
sleeve
clockwise to tighten the chuck.
To remove the bit, hold the ring and turn
the
sleeve
counterclockwise.
Sleeve
k
Switch action
Tool speed i s increased
by
increasing pres-
sure on the trigger. To start the tool, simply
pull the trigger. Release the trigger to stop.
CAUTION
:
Before inserting the battery cartridge into the tool, always check to
see
that the switch
trigger actuates properly and returns to the "OFF" position when released.
Reversing switch action
This tool has
a
reversing switch to change
the direction of rotation. Slide the revers-
ing switch to the left for clockwise rota-
tion or to the right for counterclockwise.
CAUTION :
Always check the direction of rotation before operation.
*Move the reversing switch only after the tool comes to a complete stop. Changing the
direction of rotation before the tool stops may damage the tool.
7
Advertisement
