Repair; Curtain; Inlet Water Valve - Scotsman DCE33 User Manual

REPAIR

Curtain

The curtain keeps the water that sprayed by the
pump from falling in the bin.
The "sheet" type curtain is replaced by:
1. Removing 4 screws holding the curtain and the
curtain stiffener to reservoir.
2. Pulling the curtain and curtain stiffener out of the
machine.
3. Replace with a new curtain and install as shown.
Curtain
Sheet
Type:
Curtain
Stiffener
Bottom Edge
Angle to Rear
Curtain and Curtain Stiffener MUST Be Installed
Electrical Shock Hazard
Disconnect Electrical
Power Before Beginning
Removal of Parts
Front Edge
of Reservoir
As Shown

Inlet Water Valve

The inlet water valve may need to be cleaned or
replaced. If there is not enough water coming into
the machine, the valve may need to be cleaned. If
the valve does not work at all, or does not shut off
tightly, it should be replaced.
1. Unplug or disconnect electrical power.
2. Shut off water supply
3. Remove kickplate
4. Remove the control box cover.
5. Unscrew flare nut from inlet water valve inlet . If
the valve is being replaced, proceed to step 10.
6. Unscrew brass fitting from body of inlet water
valve.
Inlet Water Valve
Screen
Inlet
Curtain
Check the screen of the valve, it may be clogged
Screw
and is restricting the flow of water into the
machine. If that is the problem, clean the screen
and reverse the steps so far to reassemble.
7. Loosen the screws in the back of the control
box, and remove the inlet water valve.
8. Remove the discharge hose from the outlet of
the water valve.
9. Unplug the wire harness from the top of the
valve.
10. Replace with a new valve, and reverse the
above steps to reassemble.
August 1995
Page 21
DCE33
SERVICE OF THE INLET
WATER VALVE
Outlet