Table of Contents
Advertisement
3
1. Arm
2. Wrench holder
3. Socket wrench
1
1. Stopper pin
1
2
3
1. Blade Case
2. Hex bolt
3. Socket wrench
4. Blade guard
12
Socket wrench storage
002200
1
The socket wrench is stored as shown in the figure. When
2
using the socket wrench, pull it out of the wrench holder.
After using the socket wrench, return it to the wrench holder.
Installing or removing saw blade
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before installing or removing the blade.
•
Use only the Makita socket wrench provided to install or
remove the blade. Failure to do so may result in
overtightening or insufficient tightening of the hex bolt.
This could cause an injury.
Lock the handle in the raised position by pushing in the stop-
002201
per pin.
To remove the blade, use the socket wrench to loosen the
002215
hex bolt holding the center cover by turning it counterclock-
wise. Raise the blade guard and center cover.
4
Advertisement
Table of Contents
