Back-Up Lamps - Cadillac 2014 SRX Owner's Manual

10-30 Vehicle Care
4. Remove the two screws from the
taillamp assembly.
5. Pull the taillamp assembly
straight back to remove.
6. Turn the turn signal lamp bulb
socket counterclockwise to
remove it from the taillamp
assembly.
7. Pull the bulb straight out from
the socket.
8. Press a new bulb into the
socket, insert it into the taillamp
assembly, and turn the bulb
socket clockwise until it clicks.
9. Reinstall the taillamp assembly
and tighten the screws.
10. Reinstall the taillamp cover by
snapping it into place.
I n f o r ma t i o n P r o v i d e d b y :
11. Push the push pin to secure
the taillamp cover.

Back-Up Lamps

To replace one of these bulbs:
1. Open the liftgate. See Liftgate
on page 2-13.
2. Remove the push pin (1) on the
taillamp cover (2).
3. Remove the taillamp cover from
the lamp assembly by pulling
rearward from the top to
unfasten from the snap tabs.