Arranque / Parada Del Motor - Stihl TS 480i Instruction Manual

Hide thumbs Also See for TS 480i:
Table of Contents

Advertisement

Available languages

Available languages

Arranque / parada del motor

3
3
1
2
Press throttle trigger lockout (1) and
N
then throttle trigger (2)
Hold both lockout and trigger down
N
simultaneously
Move the stop switch (3) to F
N
Release the throttle trigger, stop
N
switch and throttle trigger lockout in
succession – starting throttle
position
TS 480i, TS 500i
5
Press the button (4) of the
N
decompression valve before each
starting procedure
Press the manual fuel pump bulb (5)
N
7-10 times, even when the bulb is
filled with fuel
Starting
Place the cut-off machine carefully
N
on the ground, ensuring that the
abrasive wheel cannot touch the
ground or any objects. There must
not be any bystanders near the cut-
4
off machine
Make sure you have a firm footing
N
Press the cut-off machine firmly
N
against the ground, holding the front
handle with your left hand, thumb
wrapped round the handle
Press the cut-off machine against
N
the ground with the right knee on the
shroud
Pull the starter grip slowly with your
N
right hand until you feel it engage –
then give it a brisk strong pull – do
not pull out the starter rope all the
way
INDICACIÓN
Do not let the starter grip snap back – it
may break! Guide it back into the
housing in the opposite direction so that
it can rewind properly.
Once the engine is running
Let the engine run for a few seconds
N
- important: the abrasive wheel may
begin to rotate!
Blip the throttle trigger and throttle
N
trigger lockout so that the engine
settles down to idle speed
The cut-off machine is now ready for
use.
ADVERTENCIA
The abrasive wheel must not rotate
when the engine is idling. Have the
machine repaired by a STIHL servicing
español / EE.UU
85

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Ts 500i

Table of Contents