Installing A Memory Module - Toshiba U940 User Manual

Use a point size 0 Phillips screwdriver to remove and fasten the screws -
the use of an incorrect screwdriver can damage the screw heads.

Installing a memory module

To install a memory module, follow the steps as detailed below:
1. Click Power in the Settings charm, and then click Shut down while
holding down the SHIFT key - ensure that the Power indicator is off.
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Close the display panel.
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack
5. Loosen the screw securing the memory module cover in place -
please note that the screw is attached to the cover in order to prevent
it from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
1. Memory module cover
Product appearance depends on the model you purchased.
User's Manual
section, if required).
Figure 4-7 Removing the memory module cover
2
1
2. Screw
4-15