Table of Contents
Advertisement
Authentication Policy & Parameter Settings
This command will enable an administrator-defined authentication policy for users trying to access the Switch. When enabled, the
device will check the Login Method List and choose a technique for user authentication upon login.
To view this window, click Security > Access Authentication Control > Authentication Policy & Parameter Settings, as
shown below:
Figure 6 - 35 Authentication Policy and Parameter Settings window
The following parameters can be set:
Parameter
Authentication Policy
Response Timeout (0-
255)
User Attempts (1-255)
Click Apply to implement changes made.
Application's Authentication Settings
This window is used to configure switch configuration applications (console, Telnet, SSH, web) for login at the user level and at
the administration level (Enable Admin) utilizing a previously configured method list.
To view this window, click Security > Access Authentication Control > Application Authentication Settings, as shown below:
The following parameters can be set:
®
xStack
DGS-3426G Layer 2 Gigabit Ethernet Managed Switch
Description
Use the drop-down menu to enable or disable the Authentication Policy on the Switch.
This field will set the time the Switch will wait for a response of authentication from the
user. The user may set a time between 0 and 255 seconds. The default setting is 30
seconds.
This command will configure the maximum number of times the Switch will accept
authentication attempts. Users failing to be authenticated after the set amount of attempts
will be denied access to the Switch and will be locked out of further authentication
attempts. Command line interface users will have to wait 60 seconds before another
authentication attempt. Telnet and web users will be disconnected from the Switch. The
user may set the number of attempts from 1 to 255. The default setting is 3.
Figure 6 - 36 Application Authentication Settings window
253
Advertisement
Table of Contents
