Empty Dust Cup; Maintenance; Empty The Dust Cup; Clean Filters - Shark Rotator NV680UKT Instruction Manual

MAINTENANCE

To keep your vacuum's suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
IMPORTANT: Allow ALL filters to dry completely before replacing into the vacuum.
STEP 1

EMPTY THE DUST CUP

1 Pull up on the dust cup release latch and lift the dust
cup off the pod.

CLEAN THE FILTERS

1 With the dust cup removed, remove and rinse the foam
and felt filters every 3 months. Let air dry completely
before replacing. Hand wash only. Tap loose dirt off
filters between washes as needed.
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-motor Filter Kit (Foam & Felt):
Post Motor Filter:
9
2 Holding the dust cup over a rubbish bin, press the
bottom empty release latch.
2 Once a year open the filter grill and remove and
rinse the HEPA filter. Let air dry completely before
replacing. Hand wash only.
WARNING: DO NOT PICK UP FIREPLACE ASH
OR DRYWALL DUST.
Every 3 months
XFF680
Every year
XHF680
STEP 2
s h a r k c l e a n . e u
w w w .
STEP 3
3 Press the top dust cup release latch to access the dust
screen and remove built-up debris as required.
FOAM FILTER
FILTER FRAME
FELT FILTER
HEPA