3000 Series Maintenance Leveling; Removing And Installing Grille; Adjusting Grille - U-Line U-3018RFOL-00 Service Manual

General Information
3000 Series Maintenance
Leveling
NOTICE
Unit must be level for proper door operation.
1. Use a level to check the levelness of the unit from front to back
and from side to side. Place the level along top edge and side edge
as shown (1).
2. If the unit is not level, rotate the adjustable leveling legs to raise
or lower each corner of the unit (2) as necessary.
1
3. To rotate rear leveler legs remove grille. See Removing and
Installing Grille.
4. Using the provided 6mm T bar Allen wrench, rotate the 2
adjustment screws as shown below.
Rotate Forward Feet to Adjust
Rotate Clockwise to raise rear leg.
Rotate Counter-Clockwise to lower leg.
Note: Do not use any power tools to adjust the leveler legs.
5. Check levelness after each adjustment and repeat the previous
steps until the unit is level.
24

Removing and Installing Grille

!
• Disconnect electrical power to the unit before
removing the grille.
• Edges of sheet metal may be sharp.
Removing the grille
1. Disconnect power to unit.
2. Using the included 7/64" Allen wrench, loosen, but do not
remove both grille lock screws. See below.
3. Gently pull grille away from unit until it stops.
4. Push grille rails towards the center of the unit to lift rails off lock
screws.
5. Pull grille free from unit.
Installing the grille
1. Align slots in grille rail with screw heads in base of unit.
2. Push grille rails towards the center of the unit and set rails over
2
screw head.
3. Slide grille into position. Using included 7/64" Allen wrench,
tighten grille lock screws.

Adjusting Grille

The grille has an automatic vertical plane adjustment and can also be
adjusted on its horizontal plane as well. To adjust your grille to match
your surrounding cabinetry follow the instructions below.
1. Loosen, but do not remove, the lock screws on the inside of the
grille rails. Lock screws are located on the inside of each grille
rail.
2. Pull grille out to desired position and secure lock screws.
3. The grille skirt may be manually adjusted to the height of your
floor. Simply raise or lower the skirt as needed.
u-line.com
WARNING
Grille Mounting
Screws
Grille
Skirt