Asus SD324-YB User Manual page 5

Polish Center for Testing and Certification
Notice
The equipment should draw power from a socket with an
attached protection circuit (a three-prong socket). All equipment
that works together (computer, display, printer, and so on)
should have the same power supply source.
The phasing conductor of the room's electrical installation
should have a reserve short-circuit protection device in the form
of a fuse with a nominal value no larger than 16 amperes (A).
To completely switch off the equipment, the power supply cable
must be removed from the power supply socket, which should
be located near the equipment and easily accessible.
A protection mark "B" confirms that the equipment is in
compliance with the protection usage requirements of standards
PN-93/T-42107 and PN-89/E-06251.
Electric, Magnetic and Electronmagnetic
Fields ("EMF")
1. We manufacture and sell many products targeted at
consumers, which, like any electronic apparatus, in general
have the ability to emit and receive electromagnetic signals.
2. One of our leading Business Principles is to take all
necessary health and safety measures for our products, to
comply with all applicable legal requirements and to stay
well within the EMF standards applicable at the time of
producing the products.
3. We are committed to develop, produce and market products
that cause no adverse health effects.
4. We confirm that if its products are handled properly for their
intended use, they are safe to use according to scientific
evidence available today.
5. We play an active role in the development of international
EMF and safety standards, enabling us to anticipate further
developments in standardization for early integration in its
products.
Information for U.K. only
WARNING – THIS APPLIANCE MUST BE EARTHED.
Important:
(B)
This apparatus is supplied with an approved moulded 13A plug.
To change a fuse in this type of plug proceed as follows:
1. Remove fuse cover and fuse.
2. Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI
approved type.
3. Refit the fuse cover.
If the fitted plug is not suitable for your socket outlets, it should
be cut off and an appropriate 3-pin plug fitted in its place.
If the mains plug contains a fuse, this should have a value of
5A. If a plug without a fuse is used, the fuse at the distribution
board should not be greater than 5A.
NOTE: The severed plug must be destroyed to avoid a
possible shock hazard should it be inserted into a 13A
socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured in accordance with the
following code:
BLUE – "NEUTRAL" ("N")
BROWN – "LIVE" ("L")
GREEN & YELLOW – "EARTH" ("E")
1. The GREEN & YELLOW wire must be connected to the
terminal in the plug which is marked with the letter "E" or
by the Earth symbol or coloured GREEN or GREEN &
YELLOW.
2. The BLUE wire must be connected to the terminal which is
marked with the letter "N" or coloured BLACK.
3. The BROWN wire must be connected to the terminal which
marked with the letter "L" or coloured RED.
Before replacing the plug cover, make certain that the cord grip
is clamped over the sheath of the lead – not simply over the
three wires.
v
SD324-YB/ SD424-YB/ SD554-YB
(A)