Shop Tools; Warehouse & Dock products; Hand Tools; Air Tools NOTE: JET is a division of JPW Industries, Inc. References in this document to JET also apply to JPW Industries, Inc., or any of its successors in interest to the JET brand.
10. The air tool must be properly lubricated before operating. Do not use this tool for other than its intended use. If used for other purposes, JET disclaims 11. Never start a percussion type air tool (chipper, any real or implied warranty and holds itself breaker, buster, etc.) without securing the...
Page 4
22. Shut off air supply and discharge any residual 33. Do not lubricate the tool with combustible pressure from tool before removing hose, liquids, such as kerosene, diesel or jet fuel. making adjustments, changing accessories, 34. Do not dispose of this tool with normal or storing tool.
As with any tool operation, safety of operator and bystanders should be first priority. If there are questions or comments, please contact your local supplier or JET. JET can also be reached at our web site: www.jettools.com.
Specifications were current at time of publication, but because of our policy of continuous improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring obligations.
Regulator settings are for reference only and do not indicate specific power Any missing parts or damage should be reported settings. ® immediately to your JET distributor. Do not use a damaged tool. Read this instruction manual Select rotation...
Tool Pressure Use proper air hose size (refer to tool specifications). The hose should be just long JET Air Tools operate on 70-to-100 psi (pounds enough to serve the working area. Excessive per square inch) air pressure measured at the tool hose length will cause pressure drop.
Page 9
Use a light oil containing rust inhibitors, such as replaceable air filter that can be easily cleaned. SAE #10. Many JET air tools have integral oil reservoirs, which should be kept filled when in-line Use safety shut-off valves so air flow can be oilers are not used.
Page 10
Troubleshooting JAT-120/121/122/123 Impact Wrenches Any disassembly of the tool should be done by qualified service personnel. For problems not addressed below, contact JET technical service at 800-274-6846. Problem Possible cause Remedy Tool will not start. Air valve closed or obstructed.
Problem Possible cause Remedy Severe air leakage. Air valve obstructed or damaged. Clean or replace. (Note: Minimal escape of Housing loose or damaged. Tighten or replace as needed. air is often normal for air tools.) Replacement parts Service parts are listed on the following pages. To order parts or reach our service department, call 1-800- 274-6848 Monday through Friday, 8:00 a.m.