Specifications - Stihl MS 193 Instruction Manual

English

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB
The Emission Compliance Period used
on the CARB-Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
52
MS 193 C
Displacement: 1.84 cu.in
(30.1 cc)
Bore: 1.46 in (37 mm)
Stroke: 1.10 in (28 mm)
Engine power to
ISO 7293: 1.7 bhp (1.3 kW)
Idle speed: 3,000 rpm
Max. permissible
speed (with cutting
attachment): 13,000 rpm
Ignition System
Electronic
Spark plug (resistor
type): NGK CMR 6 H
Electrode gap: 0.020 in (0.5 mm)
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity: 9.1 fl.oz (0.27 l)
Chain Lubrication
Fully-automatic speed-controlled oil
pump with rotary piston
Oil tank capacity: 7.4 fl.oz (0.22 l)
Weight
Weight (dry, with-
out bar and chain): 7.7 lbs (3.5 kg)
Cutting Attachments
Recommended cutting attachments
conforming with the 45 degree
computed kickback angle requirement
of Section 5.11 of
ANSI/OPEI B175.1-2012 when used on
this model chain saw (see the chapter
on "Safety Precautions and Working
Techniques"):
Rollomatic E guide bars
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30, 35, 40 cm
(12, 14, 16 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.1 mm (0.043 in)
Sprocket nose: 7-tooth
Actual cutting length will be less than
listed bar length.
Rollomatic E Light guide bars
Reduced kickback STIHL guide bars
(with green label)
Bar lengths: 30, 35, 40 cm
(12, 14, 16 in.)
Pitch: 3/8" P (9.32 mm)
Groove width: 1.3 mm (0.050 in)
Sprocket nose: 9-tooth
Actual cutting length will be less than
listed bar length.
MS 193 C