Makita 4351T Instruction Manual
Jig saw
Hide thumbs
Also See for 4351T:
- Instruction manual (61 pages) ,
- Technical information (15 pages) ,
- Specifications (2 pages)
Related Manuals for Makita 4351T
Summary of Contents for Makita 4351T
- Page 1 INSTRUCTION MANUAL Jig Saw 4351T 4351CT 4351FCT 008029 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
EN60745: Directive, Waste Electric Electronic Equipment Model 4351T implementation in accordance with Work mode : cutting boards national law, electric equipment that Vibration emission (a ) : 7.0 m/s have reached the end of their life must Uncertainty (K) : 1.5 m/s... -
Page 3: General Power Tool Safety Warnings
Electrical safety Jig Saw Power tool plugs must match the outlet. Never Model No./ Type: 4351T, 4351CT, 4351FCT modify the plug in any way. Do not use any Conforms to the following European Directives: adapter plugs with earthed (grounded) power 2006/42/EC tools. -
Page 4: Jig Saw Safety Warnings
Personal safety 22. Maintain power tools. Check for misalignment Stay alert, watch what you are doing and use or binding of moving parts, breakage of parts common sense when operating a power tool. and any other condition that may affect the Do not use a power tool while you are tired or power tool’s operation. -
Page 5: Functional Description
Always switch off and wait for the blade to FUNCTIONAL DESCRIPTION come to a complete stop before removing the blade from the workpiece. 12. Do not touch the blade or the workpiece CAUTION: immediately after operation; they may be Always be sure that the tool is switched off and •... - Page 6 To start the tool, slide the switch lever to the "I" position. NOTE: To stop the tool, slide the switch lever to the "O" position. Use a dry cloth to wipe the dirt off the lens of lamp. • Speed adjusting dial Be careful not to scratch the lens of lamp, or it may lower the illumination.
-
Page 7: Bevel Cutting
CAUTION: Bevel cutting Do not open the tool opener excessively, or it may • cause tool damage. To remove the blade, open the tool opener to the position shown in the figure. Pull the saw blade out toward the base. 1. -
Page 8: Metal Cutting
Then connect a Makita vacuum cleaner to the dust Apply pressure to the tool so that the front nozzle. edge of the base will not move when you switch on the tool and gently lower the back 1. - Page 9 When cutting circles or arcs of 170 mm or less in Rip fence set (optional accessory) radius, install the rip fence as follows. Insert the rip fence into the rectangular hole on the CAUTION: side of the base with the fence guide facing up. Always be sure that the tool is switched off and •...
-
Page 10: Cover Plate
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Jig saw blades • Hex wrench 4 • Rip fence (guide rule) set •... - Page 12 Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan www.makita.com 884716F229...