Cadillac SRX 2016 Owner's Manual page 58

2. Adjust the driver seat, power tilt
and telescoping steering
column (if equipped), and the
outside mirrors on some
vehicles.
3. Press and hold MEM (Memory)
and 1 until three beeps sound.
4. Repeat Steps 1 3 for a second
driver using 2.
Manually Recalling Memory
Positions
Press and hold 1 or 2 to manually
recall the previously stored memory
positions. Releasing 1 or 2 before
the stored positions are reached
stops the recall.
Automatically Recalling Memory
Positions (Auto Memory Recall)
When enabled in the vehicle
personalization menu, the Auto
Memory Recall feature recalls the
previously stored memory 1 or 2
positions when the ignition is
changed from OFF to ON/RUN or
ACC/ACCESSORY.
To activate, place the ignition in ON/
RUN or ACC/ACCESSORY.
RKE transmitters are not labeled
with a number. If your memory seat
position is stored to 1 or 2, but this
position is not automatically
recalling, then change the stored
position or switch RKE transmitters
with the other driver.
See "Auto Memory Recall" under
"Comfort and Convenience" in
Vehicle Personalization 0 147.
To stop recall movement, press one
of the memory, power mirror,
or power seat controls, or the power
tilt and telescoping steering column
controls. If On - At Ignition On is
selected in the vehicle
personalization menu, placing the
ignition in OFF also stops the recall.
Easy Exit Recall
If programmed on in the vehicle
personalization menu, this feature
automatically moves the seat
approximately 7 cm (3 in) rearward
allowing the driver more room to exit
the vehicle.
Seats and Restraints
Easy Exit recall activates when one
of the following occurs:
The vehicle is turned off and the
driver door is opened within a
short time.
The vehicle is turned off with the
driver door open.
See Vehicle Personalization 0 147.
To stop recall movement, press one
of the memory, power mirror,
or power seat controls.
Obstructions
If something has blocked the driver
seat while recalling a memory
position, the recall may stop.
Remove the obstruction. Then do
one of the following:
If automatically or manually
recalling the stored memory
position, press and hold the
appropriate manual control for
two seconds. Try recalling again
by pressing the appropriate
memory button, then try recalling
again by opening the driver door
and pressing on the RKE
transmitter.
57