IDENTIFICATION OF CONTROLS
1
ATTENTION
Please make sure all ancillary equipment is turned off and that the MT2
is not yet connected to its dedicated power supply.
1 LED INDICATOR
•
This LED indicates the status of the MT2. Below is a description of
the LED indicator colors.
LED COLOR
Fast flashing blue
Slow flashing blue
Alternately flashing blue and pink
Flashing red
Solid blue
4
DESCRIPTION
Powering up
Boot up/reboot
No WiFi connection
Hot spot mode
Reset mode
WiFi connected
2
3
4
2 RESET
•
The RESET button restores the MT2 to its factory default settings.
•
Use a paper clip or similar to poke the RESET button – the front LED
flashes red. Release paper clip. MT2 will reset and reboot itself.
3 SETUP
•
The SETUP button initiates wireless configuration.
•
Press and hold SETUP button until the front LED indicator
alternately flashes blue and pink. The MT2 is now at Hotspot mode.
•
Refer also to the section below about WIRELES CONNECTION
CONFIGURATION.
4 ANALOG OUT
•
Plug-in the 3.5mm mini-stereo end of the supplied analog audio
adaptor to this port. Then, connect the two RCA male ends of the
adaptor to applicable analog audio input of a receiver, amplifier or
any compatible device.
5 OPTICAL OUT
•
Using a TOSLINK optical cable (not supplied), connect OPTICAL OUT
to corresponding optical digital audio input of compatible devices
such as receivers, computer soundcard or other digital processors.
6 SERVICE
•
For servicing purposes only. Not for consumer use. Only authorized
NAD service personnel can access this SERVICE port.
7 5V DC IN
•
Before connecting the supplied Plug-in Power Supply to the wall
outlet, connect firmly first the other end to MT2's 5V DC IN.
•
Always disconnect the Plug-in Power Supply from the wall outlet
first, before disconnecting the cable from MT2's 5V DC IN.
5
6
7