Brake Fluid Check; Adding Engine Coolant - Ford 2015 Figo Owner's Manual

Adding Engine Coolant

WARNINGS
Only add coolant when the engine is
cold. If the engine is hot, wait 10
minutes for the engine to cool down.
Do not remove the filler cap when
the engine is running.
Do not remove the filler cap when
the engine is hot. Wait for the engine
to cool down.
Undiluted coolant is flammable and
may ignite if spilt on a hot exhaust.
Note: Inspect or replace the lid with the
vehicle turned off and the engine cold, to
avoid injuries or burns.
Note: In an emergency, you can add just
water to the cooling system to reach a
vehicle service station. Have the system
checked by an authorized dealer as soon as
possible.
Note: Prolonged use of incorrect dilution
of the coolant can cause engine damage
from corrosion, overheating or freezing.
Note: Do not add coolant further than the
MAX mark.
Note: If coolant levels are outside the
standard operational range, the
performance of the system may be
compromised; seek an authorized dealer
immediately.
Note: The cooling system expansion
reservoir lid should be inspected and
cleaned every 3 years approximately. If there
are any evidences of deterioration of the
sealing ring, the lid should be replaced.
Note: It is normal to see some air bubbles
in the coolant reservoir fluid.
1. Remove the filler cap. Any pressure will
escape slowly as you unscrew the cap.
Figo (CDU) , E4B5 19A321 ZCA enIND, Edition date: 06/2015, Second Printing
Maintenance
2. Add a mixture of 50% coolant and
50% water using fluid that meets the
Ford specifications. See Capacities
and Specifications (page 162).
3. Replace the filler cap. Turn it clockwise
until you feel a strong resistance and
it clicks.

BRAKE FLUID CHECK

Do not use any fluid other than the
recommended brake fluid as this will
reduce brake efficiency. Use of
incorrect fluid could result in the loss of
vehicle control, serious personal injury or
death.
Only use brake fluid from a sealed
container. Contamination with dirt,
water, petroleum products or other
materials may result in brake system
damage or failure. Failure to adhere to this
warning could result in the loss of vehicle
control, serious personal injury or death.
Do not allow the fluid to touch your
skin or eyes. If this happens, rinse the
affected areas immediately with
plenty of water and contact your physician.
A fluid level between the MAX and
MIN lines is within the normal
operating range and there is no need
to add fluid. A fluid level not in the normal
operating range could compromise the
performance of the system. Have your
vehicle checked immediately.
129
WARNINGS