Table of Contents
Advertisement
Quick Links
Remote Mobile Security System
OWNER'S
MANUAL
Model: PL30
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
© Copyright 1998 Magnadyne Corp.
Advertisement
Table of Contents
Related Manuals for Magnadyne PL30
Summary of Contents for Magnadyne PL30
- Page 1 (2) This device must accept any interference received, including interference that may cause undesired operation. Note: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment. © Copyright 1998 Magnadyne Corp.
-
Page 2: Security System Operation
The information enclosed will provide a ready reference of the operation and maintenance of your new remote mobile security system. Remote Control Transmitters Your security system can operate from any one of the four transmitters shown here. Locate the transmitter that was supplied with your system and use the drawing as a ready reference while reading through the operating procedures. - Page 3 Automatic Arming: (Without using the transmitter) Note: The following information is valid only if your security system has been programmed to automatically arm. 1. Turn off the ignition key and exit the vehicle. 2. Close all protected entrances. After the last protected entrance is closed the horn/siren will chirp one time and the LED indicator will begin to flash fast.
- Page 4 Valet/Override Switch Operation: Valet Switch in the ON Position Override Operation: (Security System is Armed) 1. Enter the vehicle. (The security system will begin sounding at this point) 2. Place the ignition key into the ignition switch and turn the ignition switch to the “on” position. 3.
-
Page 5: Remote Panic
Remote Panic Press and hold the ARM/DIS or PANIC or LOCK button for more than 3 seconds and the security system will respond in the following manner: A. The horn/siren will begin sounding. B. The parking lights will begin flashing. To turn off the panic alarm, press and release the ARM/DIS or PANIC button on the transmitter. -
Page 6: Upgrade Options
Alarm Mode Indicators 1. The LED indicator will provide information on 7 modes of security system operation: LED is off = Security system is disarmed. LED is flashing = Security system is armed. LED is flashing fast = Automatic arming timer or RF protection mode timer is counting down. LED is on solid = Security system is in valet mode. -
Page 7: Programmable Features
Programmable Features: The following is a brief description of the operation of each programmable feature. Any adjustment to the operation of these features must be performed by the dealer who installed your security system. These features are not user adjustable. Ignition Key Controlled Door Lock/ Unlock: (Remote door lock/unlock option must be installed) With this feature activated, the door lock system of the vehicle will become locked 3 seconds after the ignition key is turned to the on position (All doors). -
Page 8: Limited Lifetime Warranty
Magnadyne Corporation or its authorized agents will, for the life of the vehicle and to the original purchaser, repair, replace or refund the retail sales price of said product or any part thereof, at the option of the Magnadyne Corporation or its authorized agents, if said product or part is found defective in materials or workmanship, when properly connected and operating on the correct power requirements designated for the specific product.