Size And Depth Of Buried Objects; Emi) Electromagnetic Interference; Operation And Controls - Bounty Hunter Gold Owner's Manual

OPERATION and CONTROLS

NOTCH
continued
For example, the following settings
tell us that:
• The nickel, dime, quarter and
50¢+ categories will
detected.
• All other categories of targets
(iron, foil, alum and zinc) will
not be detected.
3. SENSITIVITY
Use and to increase or
decrease sensitivity while the SENS line is highlighted.
Maximum sensitivity is indicated by 5 bars.
Minimum sensitivity is indicated by 1 bar.
If the detector beeps erratically or beeps when there are no metal objects
being detected, reduce the sensitivity.
The searchcoil produces a magnetic field and then detects changes in that
magnetic field caused by the presence of metal objects. This magnetic field that
the detector creates is also susceptible to the electromagnetic energy produced by
other electronic devices. Power lines, microwave ovens, lighting fixtures, TVs,
computers, motors, etc.... all produce EMI which can interfere with the detector
and cause it to beep when no metal is present, and sometimes to beep erratically.
HOW DEEP WILL IT GO?
The Gold Metal Detector will detect a coin-sized object, like a quarter, to a
distance of about 9" from the searchcoil. Large metal objects can be
detected to a depth of several feet. Detectability is directly related to the size
of the metal object -- the larger the object, the deeper it can be detected.
Accuracy of target identification is also related to distance from the coil. Beyond
a distance of 8", the accuracy of target identification begins to diminish.
4. VOLUME
While the VOLUME line is highlighted, use
speaker volume.
The default volume setting is 9. Maximum is 9.
Minimum is 0 (volume off). At levels 1, 2 and 3, high tones will be
inaudible or barely audible.
The speaker volume will diminish as battery voltage drops.
maximum speaker volume, use 1 or 2 tones, as the low and bass tones
generate the loudest sounds.
12
( cont.)
be
menu
and to change the
THE BASICS

4. Size and Depth of Buried Objects

The relative depth of an object is displayed at the left of the display as
a 1 digit number, 0 to 9 inches. The size of an object can be
determined using sweep techniques described later in the manual.

5. (EMI) Electromagnetic Interference

The searchcoil produces a magnetic field and then detects changes in
that magnetic field caused by the presence of metal objects. This
magnetic field that the detector creates is also susceptible to the
electromagnetic energy produced by other electronic devices. Power
lines, microwave ovens, lighting fixtures, TVs, computers, motors,
etc.... all produce EMI which can interfere with the detector and cause
it to beep when no metal is present, and sometimes to beep erratically.
The SENSITIVITY control lets you reduce the strength of this magnetic
field, and therefore lessen its susceptibility to EMI. You may want to
operate at maximum strength, but the presence of EMI may make this
impossible, so if you experience erratic behavior or "false" signals,
reduce the sensitivity.
For
( continued)
9