Table of Contents
Advertisement
Instructions for use
GB
English,1
HV8F 292
WASHING MACHINE
Contents
Installation, 2-3-4-5
Connecting the electricity and water supplies
Cutting off the water or electricity supply
Wash cycles, 10
Personalisation, 11
Troubleshooting, 13-14
Assistance, 15-16
GB
1
Advertisement
Table of Contents
Troubleshooting
Related Manuals for Hotpoint HV8F 292
Summary of Contents for Hotpoint HV8F 292
-
Page 1: Table Of Contents
Caring for the door and drum of your appliance Cleaning the pump Checking the water inlet hose Precautions and tips, 7 General safety Disposal HV8F 292 Description of the washing machine and starting a wash cycle, 8-9 Control panel Indicator lights Starting a wash cycle... -
Page 2: Unpacking And Levelling
Installation ! Keep this instruction manual in a safe place 2. If the floor is not perfectly level, compensate for future reference. Should the appliance be for any unevenness by tightening or loosening the adjustable front feet (see figure); the an- sold, transferred or moved, make sure the gle of inclination, measured according to the instruction manual accompanies the washing... -
Page 3: Connecting The Drain Hose
Connecting the drain hose • the supply voltage is included within the values indicated on the Technical Data Plate Connect the drain fixed on the machine. hose, without bending • the socket is compatible with the washing it, to a draining duct machine’s plug. -
Page 4: The First Wash Cycle
As the colours of the wires in the lead may not ! The power supply cable must only be repla- correspond with the coloured markings iden- ced by an authorised serviceman. tifying the terminals in your plug, proceed as follows: Warning! The company denies all liability if and Connect Green &... -
Page 5: Technical Data
Technical data Model HV8F 292 width 59.5 cm Dimensions height 85 cm depth 60 cm Capacity from 1 to 8 kg Electrical please refer to the technical connections data plate fixed to the machine maximum pressure 1 MPa (10 bar) -
Page 6: Care And Maintenance
Care and maintenance Cutting off the water and electri- 2. unscrew the lid city supplies by rotating it anti- clockwise (see figu- • Turn off the water tap after every wash cycle. re): a little water may This will limit wear on the hydraulic system in- trickle out. -
Page 7: Precautions And Tips
Precautions and tips This washing machine was designed and constructed in accordance with international safety regulations. The fol- lowing information is provided for safety reasons and must therefore be read carefully. General safety • This appliance was designed for domestic use only. This appliance can be used by children aged •... -
Page 8: Description Of The Washing Machine And Starting A Wash Cycle
Description of the washing machine and starting a wash cycle Control panel WASH CYCLE PROGRESS indicator lights DISPLAY DOOR ON/OFF TEMPERATURE LOCKED button button indicator light START/PAUSE SPIN SPEED button with FUNCTION Detergent dispenser drawer button indicator light buttons with indicator lights WASH CYCLE knob... -
Page 9: Indicator Lights
Indicator lights Temperature indicator light When a temperature value is selected, the corresponding The indicator lights provide important information. indicator light will illuminate. This is what they can tell you: Wash cycle phase indicator lights As the WASH CYCLE knob is rotated, the indicator lights illuminate, indicating the stages which will be performed by the machine in accordance with the selected wash cycle. -
Page 10: Wash Cycles
Wash cycles Table of wash cycles Detergents Max. Max. Description of the wash cycle temp. speed (°C) (rpm) Fabric Wash softener Essentials Cottons: extremely soiled whites. 90° 1200 2.45 180’ 60° 1200 1.20 215’ Cotton Standard 60° (1): heavily soiled whites. ... -
Page 11: Personalisation
Personalisation Setting the temperature By pressing the TEMPERATURE button to set the wash temperature (see Table of wash cycles). The temperature may be lowered, or even set to a cold wash ( ). The washing machine will automatically prevent you from selecting a temperature which is higher than the maximum value set for each wash cycle. -
Page 12: Detergents And Laundry
Detergents and laundry Detergent dispenser drawer Goodnigt Cycle (wash cycle 9). This is a silent cycle which can be run at night, when the electricity prices are lower. The Successful washing results also depend on the correct wash cycle is designed for cottons and synthetics. At the end dose of detergent: adding too much detergent will not of the cycle the machine stops while there is still water in the necessarily result in a more efficient wash, and may in fact... -
Page 13: Troubleshooting
Troubleshooting Your washing machine could fail to work. Before contacting the Technical Assistance Centre (see “Assistance”), make sure that the problem cannot be solved easily using the following list. Problem: Possible causes / Solutions: The machine does not switch on. •... - Page 14 The machine leaks (other than di- • The fill hose is loose, check both the cabinet and tap ends. spenser). • The fill hose is tight but still leaks, if so replace the rubber washers, or the fill hose is missing the rubber washer. •...
-
Page 15: Assistance
OR NON-DOMESTIC PREMISES. 5 Year Parts Guarantee Hotpoint also offers you a free 5 year parts guarantee. This additional guarantee is conditional on you registering your appliance with us and the parts being fitted by one of our authorised engineers. There will be a charge for our engineer’s time. -
Page 16: After Sales Service
Republic of Ireland: 0818 313 413 www.hotpointservice.co.uk Appliance Registration We want to give you additional benefits of Hotpoint ownership. To activate your free 5 year parts guarantee you must register your appliance with us. UK: 08448 24 24 24 Republic of Ireland: 01 230 0800 www.hotpointservice.co.uk...