KTM 250 SX-F EU Owner's Manual page 79

SERVICE WORK ON THE ENGINE
–
Remove screw plug
100940-10
–
Remove screws
100941-10
–
Pull oil filter
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
100942-10
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
100945-10
–
Insert the short oil screen
tighten.
Guideline
Plug for oil screen, short
100944-10
–
Place the long oil screen
Info
The larger inside diameter of the oil screen must face the engine case.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
–
Mount and tighten screw plug with the O-ring.
Guideline
100943-10
Plug for oil screen, long
with the long oil screen
3
. Remove the oil filter cover with the O-ring.
5
out of the oil filter housing.
6
with the magnet and a new seal ring.
1
into the screw plug, mount it with the O-ring and
2
M16x1.5
with the O-rings onto a pin wrench.
4
.
4
M12x1.5 20 Nm
(14.8 lbf ft)
10 Nm Lubricated with
(7.4 lbf ft) engine oil
M20x1.5 15 Nm
(11.1 lbf ft)
77