Manual-Test Mode; Introduction; Test Sim Insertion/Removal; Accessing The Manual-Test Mode - Motorola StarTAC130 Service Manual

Cellular Subscriber Group

MANUAL-TEST MODE

1.

INTRODUCTION

The Motorola StarTAC130 personal cellular telephones are
equipped with a manual-test mode capability. This
capability allows service personnel to take control of the
telephone, and by entering certain keypad sequences, make
the telephone perform desired functions. To enter the
manual-test mode, a Test SIM card (Part No 8102430Z02,
punchout centre)) is required.
2. TEST SIM CARD INSERTION
REMOVAL
The Test SIM card must be inserted into the unit correctly to
access manual-test mode; this should not be a problem
because the card can only fit in one way. Place the mini SIM
card in the tray and slid it into the phone.
Figure 1. Inserting the Test SIM card
To remove the SIM card from the unit, pull the mini SIM
tray sideways away from the phone.
The User Guide contains full information about inserting
© Motorola ECSG 1998
GSM StarTAC130 PERSONAL
CELLULAR TELEPHONE
MANUAL-TEST MODE
and removing the SIM card
3. ACCESSING THE MANUAL-TEST
MODE
When the Test SIM card is in place, power up the telephone.
Once the initial automatic ' wake up' sequence has taken
place correctly, depress the # key (on the units keypad) for
three seconds. After three seconds ' TEST' should appear in
the display, indicating that the unit is now in the manual-test
mode. Table 1 below shows the available manual-test
commands and their corresponding results.
Command
01# Exit manual-test mode
19# Display call processor s/w version
20# Display modem s/w version
22# Display speech coder s/w version
57# Initialize non-volatile memory
58# Display security code
58xxxxxx# Change security code
59# Display lock code
59xxx# Change lock code
60# Display International Mobile station
Equipment Identity (I.M.E.I.)
Note: If a customer should forget the security code in their
unit, it can only be read or changed by using a Test SIM card.
Table 1
Result
2/3/99
5