Appendix: Installing The Stand - Sanyo LED-32XR11F Instruction Manual

If the stand is provided, please read these instructions thoroughly before attempting this installation.
You must install your TV into the stand in order for it to stand upright on a cabinet or other flat surface. If you intend to mount your TV
on a wall or other vertical surface, you must remove the stand column.
Cautions:
Make sure that you handle your TV very carefully when attempting assembly or removal of the stand. If you are not sure of
your ability to do this, or of your ability to use the tools necessary to complete this job, refer to a professional installer or
service personnel. The manufacturer is not responsible for any damages or injuries that occur due to mishandling or
improper assembly.
When using a table or bench as an aid to assembly, make sure that you put down a soft cushion or covering to prevent
accidental scratching or damage to your TV's finish.
The speaker is not intended to support the weight of your TV. Do not move or handle your TV by the speaker. This can
cause damage to your TV that is not covered by the manufacturer's warranty.
Before attempting assembly or removal of the stand, unplug the AC power cord.
Installing the stand
Stand base
NOTE:
The appearance of this product in these illustrations may differ from your actual product, and is for comparative
purposes only.

Appendix: Installing the Stand

To install the stand:
1. Remove the stand base from the box and place it on a table or
bench.
You must pay attention to the direction of the stand. The wide
portion of the stand should go towards the front of the TV.
2. Lay your TV flat (screen down) on the edge of a table or
Stand column
bench. Make sure that you put down a soft cushion or cloth so
that your TV is not scratched.
3. Align the stand base to the stand column, secure the stand
Three screws
base to the stand column with the three provided screws using
a screwdriver.
39