Lenovo x3550 M4 Installation And Service Manual page 48

Figure 17. System-board switches, jumpers, and buttons
The following table describes the jumpers on the system board.
30
System x3550 M4 Type 7914: Installation and Service Guide
Table 2. System board jumpers
Jumper number Jumper name
JP1 CMOS clear jumper
JP2 UEFI boot backup jumper
JP6 System TPM physical
presence jumper
Notes:
1. If no jumper is present, the server responds as if the pins are set to the default.
2. Changing the position of the UEFI boot backup jumper (JP2) from pins 1 and 2 to pins
2 and 3 before the server is turned on alters which flash ROM page is loaded. Do not
change the jumper pin position after the server is turned on. This can cause an
unpredictable problem.
Jumper setting
v Pins 1 and 2: Normal (default).
v Pins 2 and 3: Clears the real-time
clock (RTC) registry.
v Pins 1 and 2: Normal (default).
Loads the primary server firmware
ROM page.
v Pins 2 and 3: Loads the secondary
(backup) server firmware ROM
page.
v Pins 1 and 2: Normal (default).
v Pins 2 and 3: Indicates a physical
presence to the system TPM.