Electrical Safety - Black & Decker CD121K Original Instructions Manual

ENGLISH
Warning! The vibration emission value during actual use of
the power tool can differ from the declared value depending
on the ways in which the tool is used. The vibration level
may increase above the level stated.
When assessing vibration exposure to determine safety
measures required by 2002/44/EC to protect persons
regularly using power tools in employment, an estimation of
vibration exposure should consider, the actual conditions of
use and the way the tool is used, including taking account of
all parts of the operating cycle such as the times when the
tool is switched off and when it is running idle in addition to
the trigger time.
Labels on tool
The following pictograms are shown on the tool:
Warning! To reduce the risk of injury, the user must
read the instruction manual.

Electrical safety

Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating plate. Never
attempt to replace the charger unit with a regular mains plug.
• If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This tool includes some or all of the following features.
1. Torque adjustment collar
2. Forward/reverse slider
3. Trigger switch
4. Chuck
5. Battery release button
Assembly
Warning! Before assembly, remove the battery from the
tool.
6
Fitting and removing the battery (fig. A)
• To fit the battery, line it up with the receptacle on the
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
• To remove the battery, push the release button (5) while
at the same time pulling the battery out of the receptacle.
Fitting and removing a drill bit or
screwdriver bit (fig. B)
Warning! First remove the battery from the tool.
• This tool is fitted with a keyless chuck to allow for an
easy exchange of bits.
• Lock the tool by setting the forward/reverse slider (2) to
the centre position.
• Open the chuck by turning the front part with one hand
while holding the rear part with the other.
• Insert the bit shank into the chuck.
• Firmly tighten the chuck by turning the front part with
one hand while holding the rear part with the other.
Removing and refitting the chuck (fig. C)
• Open the chuck as far as possible.
• Remove the chuck retaining screw by turning it
clockwise using a screwdriver.
• Tighten an Allen key into the chuck and strike it with a
hammer.
• Remove the Allen key.
• Remove the chuck by turning it counterclockwise.
• To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.
Use
Warning! Let the tool work at its own pace. Do not overload.
Charging the battery (fig. D)
The battery needs to be charged before first use and
whenever it fails to produce sufficient power on jobs that