Risk Of Fire - Craftsman 921.16578 Owner's Manual

RISK OFFIRE. Jnattended operation ofthiscompressor could result i npersonal injury o rproperty damage. To
"educe therisk offire,donotallow thecompressor tooperate u nattended. Always d isconnect
_tectrical power
by turning the pressure switch to off and drain the tank daily or after each use.
RISK TO BREATHING. &it obtained directly from the compressor should never be used to supply air for human
:::iiii_ili_::i::i:. _onsumption. The air stream may contain carbon monoxide, toxic vapors, or solid particles from
._ :ank. Breathing these contaminant's can cause serious injury or death. In order to use air produced
ay this compressor for breathing, suitable filters and in-line safety equipment must be properly
nstalted. In-line filters and safety equipment must be properly installed. In-line filters and safety
_quipment used in conjunction with the compressor must be capable of treating air to all applicable
ocal and federal codes prior to human consumption.
RISK OF INJURY _,lways operate the compressor in a stable secure position to prevent accidental movement of the
Jnit. Never operate the compressor on a table, workbench, roof or other elevated position. Use
additional air hose to reach high locations.
RISK TO HEARING. &lways wear hearing protection when using an air compressor. Failure to do so may result in
qearing loss.
i_ The interconnect cord on this product contains lead, a chemical known to the State of California to
_.ause cancer, and birth defects or other reproductive harm. Wash hands afer handling.
NOTE: ELECTRICAL WIRING. Refer to the air compressor's serial label for the unit's voltage and amperage requirements. Ensure
:hat all wiring is done by a licensed electrician, in accordance with the National Electrical code.
_i, __'_ OALIFORNIA PROPOSITION 65 WARNING: This product contains chemicals known to the State
3f California to cause cancer, birth defects and/or reproductive harm.
::)rain the moisture from the tank on a daily basis. A clean, dry tank will help prevent corrosion.
3ult the tank safety valve ring daily to ensure that the valve is functioning properly, and to clear the valve of any possible obstructions.
To provide proper ventilation for cooling, the compressor must be kept a minimum d 12 inches (31 cm) from the nearest wall, in a
_vett-ventitated area. Restricting any of the compressor ventilation openings will cause overheating and could cause fire, never place
3bjects against or on top of compressor.
-asten the compressor down securely if transporting is necessary. Pressure must be released from the tank before transporting.
_rotect the air hose and interconnect cord from damage and puncture. Inspect them weekly for weak or worn spots, and replace if
qecessary.
Risk of electric shock or injury - Use indoors only.
Dn oil-tubed compressors, oil can leak or spill and could result in fire or breathing hazard. Oil leaks will damage paint, carpet or other
surfaces in vehicles or trailers. Always place the compressor on a protective mat when transporting to protect against damage to
vehicle from leaks. Remove compressor from vehicle immediately upon approval at your destination.
To prevent damage to tank and compressor on stationary models, the tank must be shimmed so the pump base is level within 1/8" to
distribute oil properly. All feet must be supported, shimming where necessary, prior to attaching to the floor. Fasten all feet to floor. We
,also recommend the use of vibration pads (094-0137) under tank feet.
CFM: Cubic feet per minute; a unit of measure of air flow. higher than its capacity. The high pressure at which the motor
PSI: Pounds per square inch; a unit of measure of air pressure.
Cut-in pressure: While the motor is off, air tank pressure drops
as you continue to use your accessory. When the tank pressure
drops to factory set tow pressure point, the motor will restart
automatically. The tow pressure at which the motor automatically
restarts is called "cut-in" pressure.
shuts off is called "cut-out" pressure.
Well-ventilated: Means of providing fresh air in exchange for
dangerous exhaust or vapors.
Dedicated circuit: An electrical circuit reserved for the exclusive
use of the air compressor.
Cut-out pressure: When an air compressor is turned on and
begins to run, air pressure in the air tank begins to build. It
builds to the factory set high pressure point before the motor
automatically shuts off, protecting your air tank from pressure
4 200-2924