2-5. A BOARD REMOVAL
•
REMOVAL OF ANODE-CAP
Note:
Short circuit the anode of the picture tube and the anode cap to the metal chassis, CRT shield or
carbon paint on the CRT, after removing the anode.
* REMOVING PROCEDURES.
a
b
1
Turn up one side of the rubber cap in
2 Using a thumb pull up the rubber cap
the direction indicated by the arrow a
firmly in the direction indicated by the
arrow b
•
HOW TO HANDLE AN ANODE-CAP
1
Don't damage the surface of anode-cap with sharp shaped material !
Don't press the rubber hardly not to hurt inside of anode-caps !
2
A metal fitting called as shatter-hook terminal is built into the rubber.
3
Don't turn the foot of rubber over hardly !
The shatter-hook terminal will stick out or damage the rubber
Push the claw of the bracket
in the direction of the arrow
and remove.
Two Screws
Four tapping screws (M)
Anode cap
c
b
Anode button
3 When one side of the rubber cap is
separated from the anode button, the
anode-cap can be removed by turning
up the rubber cap and pulling it up in
the direction of the arrow c
.
2-6. PICTURE TUBE REMOVAL
C board
10
Speaker
4
3
13
5
14
Picture tube
Holder DGC
7
8
Degaussing coil
9
Spring tension
6
11
Neck Assy
12
Deflection
Yoke
2
1
Cushion
Chassis
Speaker
Two Screws