Disassembly - JVC RX-DP20VBK Service Manual

3.1 Main body section
3.1.1 Removing the top cover
(See Fig.1)
(1) Remove the eight screws A attaching the top cover on both
sides of the body.
(2) Remove the three screws B on back of the body.
(3) Remove the top cover from behind in the direction of the ar-
row while pulling both sides outward.
3.1.2 Removing the front panel assembly
(See Fig.2 and 3)
• Prior to performing the following procedure, remove the top
cover.
(1) Cut off the tie band 1 fixing the harness.
(2) Remove the screw a, and remove the lug wire.
(3) Remove the three screws C attaching the front panel as-
sembly.
(4) Remove the four screws D attaching the front panel as-
sembly on bottom of the body. Detach the front panel as-
sembly toward the front.
(5) Disconnect the harness from the connector CN971,
CN977, CN983 and CN985
(see fig.5), CN973 on the front AV in board and
the front DIGITAL board (see 2-3.Front panel assembly
section/ fig.2).
SECTION 3

DISASSEMBLY

on the system control board
CN373 on
Top cover
A
(both sides)
A
(both sides)
Fig.1
Front panel assembly
C
a
(fixing the
lug wire)
Audio signal
1 board
CN201
Tie band 3
Tie band 2
Y/C separator
CN581
board
CN482
CN481
V compo 2 board
Fig.2
D
Fig.3
B
C
Tie band 1
Harness
band
Audio 7.1ch
in board
CN301
Compu
link board
CN1
Tuner unit
CN1
RF remote unit
D
Front panel
assembly
(No.22008)1-7