Stopping Engine - MTD 173 cc OHV Operator's Manual

Auto-Choke System
1. Standing behind the mower, depress the blade control
handle and hold it against the upper handle. See Figure
5-3.
2
2. Pull the starter grip lightly until resistance is felt, then pull
rapidly to overcome compression, prevent kickback and
start engine. Repeat if necessary.
IMPORTANT: Do not allow the starter grip to snap back
against the engine. Return it gently to prevent damage to
the starter.
10 S 5— o
ection peration
1
Figure 5-3
Primer/Electric Start System
1. Push primer 3 times. Wait about two seconds between
each push. See Figure 5-4. In temperature below 50°F,
prime 5 times. After the engine is warmed up, one prime
may be needed for all temperatures.
2
3
Figure 5-4
2. Standing behind the mower, squeeze and hold the blade
control against upper handle.
3. Recoil Start: Pull the recoil starter lightly until resistance
is felt, then pull rapidly to overcome compression, prevent
kickback, and start the engine. Repeat if necessary. See
Figure 5-4.
IMPORTANT: Do not allow the recoil starter to snap back
against the rope guide.
Electric Start: Turn ignition key to the right to start the
engine. Release the key after the engine starts.
If engine does not start, it may be necessary to re-prime
the engine.

Stopping Engine

1. Release blade control or turn off the engine switch (if
equipped).
3
1