41300 Bluetooth Headset
Indicator LED
Power On /Off
Press & Hold to Pair
Press to make / receive calls
Previous Track
Thank you for purchasing our Bluetooth headset, to help you start using them please find the
!! PLEASE pay particular attention to step 6, you must press and hold until you see the
These are wireless Bluetooth headphones (the receiver) and will need to connect to your transmitting device such as an iPod or
tablet or smart phone. This connection is called "pairing" please note only one paired connection is allowed at anyone time so if your
device is already paired and communicating to another device then the headphones will not connect until you disconnect your
device from the other paired device, keyboard, pointer, speaker, etc. simply switching off the other device is usually sufficient.
We would always recommend fully charging the headphones prior to use, but we have shipped the unit with a storage charge so you
should be able to connect and test the headphones prior to fully charging them.
Please follow the order of these instructions as it will help speed the initial pairing process up.
1.
Unpack the headphones and ensure you have received the USB charging lead.
2.
Please fully charge the headphones (takes 4 hours maximum).
3.
Please switch on your Bluetooth device
4.
Ensure Bluetooth is enabled on your device
5.
Go to the Bluetooth device connection list on your device, (
and search for devices if not already searching.
6.
Press and hold the
released.
7.
A new device should now show in your device list e.g. "BT328"
8.
Apple devices usually say "not paired" touch this and it will connect and show connected.
9.
Other devices will act slightly different but once a new device is shown all you need to do is tap on it and follow your devices
instructions.
10.
If automatic pairing fails and a passcode is required enter "0000" four zero's.
step by step instructions below.
Play Pause button on the headphones until the LED flashes
Product Instruction Manual
41300 Bluetooth Headset
Volume UP
this is where the new connection will appear after the next step
Red
Next Track
Volume Down
Red
and
Blue
flashing LED !!
and Blue, the button can now be
)