Behringer Ultragrph Digital DEQ1024 User Manual page 8

ULTRAGRAPH DIGITAL DEQ1024
Fig. 2.4: Input/output wiring depending on operating mode
PIADB !
6hy‚t
B A
9vtv‡hy
C A
Q…rÃ@R
C B
Q‚†‡Ã@R
B A
Tab. 2.1: Input/output wiring depending on
operating mode
Fig. 2.5: Signal flow in PRE EQ mode
Fig. 2.6: Signal flow in POST EQ mode
When you keep the CLOCK switch depressed for a few
seconds, you can select the desired sample rate with
which your DEQ1024 is working: 44.1 kHz, 48 kHz or
96 kHz (green LEDs). To synchronise your DEQ1024 with
the sample rate of an external unit (e. g. through a digital
mixing console), you have to select the DIG IN setting
(yellow LED lights up).
+
8
QvxÃI‚v†rÃPI
" ! "
A A A A
A A A A
A A B A
B A A B
2. CONTROL ELEMENTS
The 12-digit LEVEL METER shows the signal level of the
input and output signals. Use the METER switch located
below it to select the respective signal, whereby the output
signal is indicated when the switch LED lights up (green),
and the input signal is indicated when the switch LED is not
lit. The red CLIP LED lights up as soon as the indicated
signal is overdriven. The GATE and the LIMITER LED
shows that the threshold of the respective dynamics
processors is either exceeded or is below the selected
value; the LED also indicates that the dynamics processor
is active at this time (see
the pink noise generator and the 24-bit word length setting
(see ) is shown on the LED METER.
Keeping the STANDBY switch depressed for a few
seconds puts the DEQ1024 into standby mode (red switch
LED lights up). In this case, the signal connected to the
DEQ1024 is looped through without being processed.
+
). Additionally, the volume of