Installing The Battery - White Outdoor LT-17 686 Operator's Manual

Positive Terminal
(Inside Rubber Boot)
Negative
Cable
Negative
Terminal
Figure 9
Battery
Strap
Hole
Drain
Tube
Transaxle
Reinforcement
Bracket
Figure 10

INSTALLING THE BATTERY

(TYPE "A" BATTERY)
NOTE:
shown on top of battery, charge for minimum of 1
hour at 6-10 amps
1. Lift the seat.
2. Remove the plastic cover from the negative
3. Remove the hex bolt and nut from the negative
Battery
Strap
INSTALLING THE BATTERY
(TYPE "B" BATTERY)
1. Lift the seat.
2. Make certain both the negative (black) cable and
3. Replace
Battery
Compartment
4. Attach the positive (red) cable to the positive
5. Remove the hex bolt and nut from the negative
Slot
in Frame
6. Secure battery by hooking battery strap into slot
7. Insert the drain tube down through the hole in
8. Trim excess end of drain tube if necessary
11
If battery is put into service after date
terminal.
(black) cable. Attach negative cable to the
negative terminal with this bolt and nut.
the positive (red) cable are routed up through
the battery compartment as shown in Figure 9.
the battery
compartment in the same position as it was
before (positive terminal is toward the front of
the unit).
terminal of the battery. Secure with hex bolt and
nut previously removed. Slide rubber boot down
over the positive terminal.
(black) cable. Attach negative cable to the
negative terminal with this bolt and nut.
in rear frame, under the fender. See Figure 10.
the battery compartment and the hole in the
transaxle reinforcement bracket located on the
right side of the unit. See Figure 10. Be certain
drain tube is routed away from the wheel rim.
(about 4" should extend past the bracket or
cable tie).
into the battery