License Plate Lamp; Replacement Bulbs - Cadillac 2012 Escalade Owner's Manual

5. Pull the old bulb straight out
from the socket.
6. Press a new bulb into the
socket, insert the socket into the
taillamp assembly and turn the
socket clockwise into the
taillamp assembly until it clicks.
7. Reinstall the taillamp assembly.
When reinstalling, make sure to
line up the pins on the taillamp
assembly with the vehicle. If the
pins do not line up correctly, the
taillamp assembly will not be
able to be installed properly.
If the taillamp, stoplamp, or turn
signal need to be replaced, see your
dealer for service.

License Plate Lamp

1. Remove the two screws holding
each of the license plate lamps
to the molding that is part of the
liftgate.
2. Twist and pull the license plate
lamp assembly forward through
the molding opening.
I n f o r ma t i o n P r o v i d e d b y :
Vehicle Care
3. Remove the bulb socket from
the lamp assembly by turning it
counterclockwise.
4. Pull the bulb straight out of the
socket and install the new bulb.
5. Reverse Steps 1 through 3 to
reinstall the license plate lamp.

Replacement Bulbs

Exterior Lamp
Number
Back-up Lamp
License
Plate Lamp (W5WLL)
For replacement bulbs not listed
here, contact your dealer.
10-37
Bulb
7441
168LL