Automatic Chain Brake; Winter Operation - Echo CS-370 Operator's Manual

END OF THE GUIDE BAR may be placed at
the height of about 35 cm.
Rear handle should be gripped lightly with
the right hand.
Plug
Cold weather
"storage" position
Warm weather position
CS-370
35 cm
Air cleaner cover
20

AUTOMATIC CHAIN BRAKE

Kickback produced from the tip of the guide bar will
trip the automatic chain brake. To make sure that
the automatic chain brake operates properly, follow
these steps:
1. Stop the engine.
2. Hold the saw with the guide bar approximately
35 cm above a wooden surface. Right hand
should hold the rear handle, and left hand should
hold the front handle.
3. Release the front handle and drop the end of the
guide bar against the wooden surface.
4. The impact should lock the chain brake.
IMPORTANT
When checking the operation of the automatic
chain brake, use a soft surface substance like
wood to provide the impact so the chain is not
damaged.

WINTER OPERATION

Use the winter kit with chain saw to prevent
carburetor trouble in winter.
• Remove air cleaner cover. Remove plug from
warm weather position, and install into cold
weather "storage" position.
NOTE
For operation at normal temperature return the
plug to its original place. (5°C)
It causes over heating of the engine.