Level 3 Service Manual
6881040B60
3.
Carefully work the flat end of the disassembly tool under the flex connector
and disconnect it from the transceiver board (See Figure 11).
DISSASSEMBLY TOOL
Figure 11. Disconnecting the Flex From the Transceiver Board
4.
Using the disassembly tool, lift the transceiver board assembly from the front
housing. To replace, insert the transceiver board assembly into the front
housing with the flex connector on top.
5.
Insert the flex connector squarely into its mating connector on the transceiver
board and press firmly until it snaps into place.
6.
Replace the metal chassis shield, rear housing assembly, antenna, battery, and
battery housing as described in the procedures.
August 01, 2002
Disassembly
FLEX
020205o
29