Related Manuals for NEAR OPS1
Summary of Contents for NEAR OPS1
- Page 1 Orbit Pendant Speaker OPS1 Installation and Use Manual © 2003 Bogen Communications, Inc. All rights reserved. Specifications subject to change without notice. 54-2090-01B 0406...
-
Page 2: Product Description
The OPS1 features a removable snap-lock input connector, providing easy wire connection for input as well as loop-through to the next speaker. IMPORTANT The OPS1 is not an outdoor speaker. Do not expose the speaker to rain or moisture.The OPS1 should be installed by qualified personnel. -
Page 3: Product Diagrams
Product Diagrams OPS1 Front Drawing 1.Tap Selection Switch 2. Coaxial Driver Assembly 3. Grille Retention Slot 4. Bass Tuning Vent (x2) 5. Perforated Steel Grille OPS1 Front Drawing (grille partially shown) OPS1 Rear Drawing 6. Snap-Lock Input Connector 7. Suspension Points (x3) 8. -
Page 4: Selecting Power Level
Selecting Power Level Select the power level using the front-mounted selector switch. The speaker grille must be removed prior to selecting the power level. See Speaker Grille Installation & Removal section for proper grille removal procedures. Selecting Power Level The front-mounted selector switch is used to set the appropriate power level or impedance for your system. -
Page 5: Speaker Wiring
All wiring should be done prior to installation and then plugged into the rear of the OPS1. Daisy-Chaining The OPS1’s snap-lock input connector allows for easy daisy-chaining of speakers by providing a second terminal of each polarity. -
Page 6: Speaker Installation
Speaker Installation Suspension Cable Assembly 1. Screw nuts onto the three (3) eyebolts all the way to the flange. Screw in eyebolts with captured cable sections into the three (3) suspension points. Do not overtighten. Snap the loops of the three (3) free ends of the cable sections into the quick-snap clip. -
Page 7: Specifications
Specifications SPECIFICATIONS OPS1 Frequency Response (-10 dB) * 60 Hz to 19 kHz " MDT Metal-Alloy Cone LF Driver (MLS Voice Coil Centering System) HF Driver 20 mm ( ") Polycarbonate Dome Sensitivity (1W/1m) 89.5 dBspl (Average 100 Hz - 10 kHz) Dispersion 120°... -
Page 8: Limited Warranty
Limited Warranty The Orbit Pendant Speaker, model OPS1, is warranted to be free from defects in mate- rial or workmanship for five (5) years from the date of sale to the original purchaser. Any part of the product covered by this warranty that, with normal installation and use,...